Support Center

Name is required.
Email address is required.
Invalid email address
Answer is required.
Exceeding max length of 5KB

Print Coltrols not showing up, just a spinning weel

David Orologio Jul 30, 2017 12:01PM PDT

I am able to upload files and send them to either printer I have, but when I am in the print que it does not show the Start, Pause / Stop or percentage of being done. I do see the Load Filament button and that works. All I see is that the printers are on line and ready to print.
I have restarted both printers multiple times, rebooted my router. This has been happening for 3 days. I have tried multiple different browsers and different PC's. I am going to try Cura for now..
Any suggestions?

Thanks!

Up 0 rated Down
David Orologio Jul 30, 2017 01:02PM PDT
FIgured it out... Went into USB mode and unlinked one of the printers. Linked it back up and it seems fine... Strange

This question has received the maximum number of answers.

Contact Us

  • Post a Public Question
  • Email Us
  • Call Us at 1-866-949-8722 (Monday-Friday, 9AM - 6PM Pacific)
4b7b2022218a46ac85636d1066ac50cc@newmatter.desk-mail.com
http://assets1.desk.com/
false
desk
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete